Tim Diagnostics - Filesystem Tab; Tim Diagnostics - Ip Parameters Tab; Tim Diagnostics - Ip Statistics Tab - Siemens SIMATIC TeleControl DNP3 Configuration Manual

Diagnostics
4.5 SINAUT special diagnostics
4.5.2.7

TIM Diagnostics - Filesystem tab

File system tab
The File system tab displays all the system data blocks and files of the individual firmware
components installed on the flash file system.
If a RAM disk is configured on the TIM, this will also be displayed with the files located there.
4.5.2.8

TIM diagnostics - IP Parameters tab

IP parameters tab
This tab is available only for the TIM 4R-IE.
The IP parameters tab displays the current IP parameters and settings of the Ethernet ports:
● IP address: Configured IP address of the module.
● Subnet mask: Configured subnet mask of the module.
● Default router: If a default router was specified during configuration, the IP address of the
default router is displayed here.
● MAC address: MAC address of the module.
● IP settings: Indicates where the module obtained the IP parameters from.
● Link status: Indicates whether or not a physical connection to Ethernet exists.
● Link settings: Shows the setting for detecting network settings, here: "automatic"
(autosensing)
● Mode: Indicates the transmission speed and direction dependency on Ethernet.
4.5.2.9

TIM diagnostics - IP statistics tab

Statistics tab
This tab is available only for the TIM 4R-IE.
The tab contains transmission statistics for the Ethernet interfaces. The number of
transferred data packets with and without errors since the last reset or restart of the module
is displayed for the send and receive directions.
142
Configuration Manual, 11/2018, C79000-G8976-C508-01
Configuration - DNP3