Siemens SIMATIC TeleControl DNP3 Configuration Manual page 104

Configuration
3.20 Configuring data points
Configuring the data points and messages in STEP 7
You configure the data points in STEP 7 in the data point and message editor. You can open
both editors alternatively as follows:
● Selecting the communications module
Shortcut menu "Open the data point and messages editor"
● Via the project navigation:
Project > directory of the relevant station > Local modules > required communications
module
By double-clicking on the entry, the data point or message editor opens.
Figure 3-7
After opening the editor window using the two entries to the right above the table, you can
switch over between the data point and message editor.
Figure 3-8
Creating obects
With the data point or message editor open, create a new object (data point / message) by
double clicking "<Add object>" in the first table row with the grayed out entry.
104
Configuring data points and messages
Switching over between the two editors
Configuration Manual, 11/2018, C79000-G8976-C508-01
Configuration - DNP3