Siemens SIMATIC TeleControl DNP3 Configuration Manual page 182

WBM of the TIM 1531 IRC
C.9 Telecontrol
– 80% limit reached
– Overflow
Transmission path
Information on the transmission path
Local CPU
● Interface ID
Ethernet interface of the TIM for connection with the local CPU
X1 (ETH1) / X2 (ETH2) / X3 (ETH3)
● CPU type
Type of the local CPU
● Connection status
– Connected
– Not connected
● CFB reference
Local ID (decimal) of the S7 connection
● Local TSAP
Local TSAP of the S7 connection
● Remote TSAP
Remote TSAP of the S7 connection
● IP address
IP address of the CPU
Remote partner
● Address
IP address or WAN address of the interface of the TIM
● Interface
Ethernet interface of the TIM for connection with the remote partner
X1 (ETH1) / X2 (ETH2) / X3 (ETH3)
● CFB reference
Local ID (decimal) of the S7 connection
182
When the ST7 protocol is used, the TIM switches to the forced image mode at 80 %
occupation of the send buffer.
100% occupation of the send buffer
Configuration Manual, 11/2018, C79000-G8976-C508-01
Configuration - DNP3