Functions And Requirements; Communications Modules - Siemens SIMATIC TeleControl DNP3 Configuration Manual

Functions and requirements

1.1

Communications modules

Communications modules for the telecontrol protocol DNP3
The following SIMATIC NET communications modules can be used for the telecontrol
protocol DNP3.
You will find the TIM 4R-IE DNP3 with article number 6NH7803-4BA00-0AA0 twice in the
STEP 7 catalog, as built-in unit (S7-300 rack) and as stand-alone device.
Meaning of symbols in the table:
● X = Supported
● - = Not supported
Table 1- 1 Communications modules for DNP3
Module
Article number
TIM 1531 IRC
6GK7 543-1MX00-0XE0
TIM 4R-IE DNP3 /
TIM 4R-IE DNP3 Stand-alone
6NH7803-4BA00-0AA0
TIM 3V-IE DNP3
6NH7803-3BA00-0AA0
CP 1243-8 IRC
6GK7 243-8RX30-0XE0
CP 1243-1
6GK7 243-1BX30-0XE0
6AG1 243-1BX30-2AX0
CP 1542SP-1 IRC
6GK7 542-6VX00-0XE0
* IE = Ethernet interfaces, RS = serial interfaces
** STEP 7 Basic with connection of the CP to a third-party master. See note below.
*** The connection of a TS-Module to the CP 1243-8 IRC is not supported for DNP3.
Configuration - DNP3
Configuration Manual, 11/2018, C79000-G8976-C508-01
Number of inter-
faces *
IE RS Master
3 1 X
2 2 X
1 1 X
1 - *** -
1 - -
1 - -
Station type
Node station Station
X X
X X
X X
- X
- X
- X
1
STEP 7 Required
product firmware
STEP 7 V2.0
Professional
STEP 7 V3.2
Professional
STEP 7 V3.2
Professional
STEP 7 V3.1
Basic ** /
Professional
STEP 7 V3.1
Basic ** /
Professional
STEP 7 V2.0
Professional
11