Siemens SIMATIC TeleControl DNP3 Configuration Manual page 162

SINEMA Remote Connect (CP)
B.2 Connection to SINEMA RC
Parameter groups
You configure communication via SINEMA RC and telecontrol communication via SINEMA
RC in two parameter groups:
● Communication via SINEMA RC:
● Telecontrol communication via SINEMA RC:
For information on the supported protocols and configuration, see section Telecontrol via
SINEMA RC (Page 163).
Applications
The following application options of the CP result from the combination of the parameters for
telecontrol communication and SINEMA RC:
● (1) No telecontrol and no SINEMA RC (CP for network separation only)
● (2) CP only for remote maintenance via SINEMA RC
● (3) CP for telecontrol communication only
● (4) CP uses telecontrol communication, but SINEMA RC only for remote maintenance.
● (5) CP uses SINEMA RC for telecontrol communication and remote maintenance.
The table provides an overview of the applications with the respective parameter settings.
● "On" means that the parameter is activated.
● "Off" means that the parameter is deactivated.
Table B- 1
* Explanation of the parameter abbreviations:
SRC - Security > VPN (activated) > "VPN connection type":
TC - Communication types > Telecontrol communication enabled
TC-SRC - Communication types >
162
> "Security > VPN"
> "Communication types"
Use cases and parameters to be activated
Use case
(1)
(2)
(3)
(4)
(5)
"Automatic OpenVPN configuration via SINEMA Remote Connect Server"
"Activate telecontrol communication via SINEMA Remote Connect"
Parameter settings
(Parameters abbreviated) *
SRC
Off
On
Off
On
On
Configuration Manual, 11/2018, C79000-G8976-C508-01
TC TC-SRC
Off
Off
On
On
On
Configuration - DNP3
Off
Off
Off
Off
On