Telecontrol Connections - Siemens SIMATIC TeleControl DNP3 Configuration Manual

Configuration

3.19 Telecontrol connections

5. As necessary, assign other passwords to the required access levels if the selected
access level permits this.
6. Download the hardware configuration so that the access level takes effect.
Result
The hardware configuration and the blocks are protected from unauthorized online access
according to the set access level. If an operation cannot be executed without a password
due to the set access level, a dialog appears prompting entry of a password.
3.19 Telecontrol connections
3.19.1 Telecontrol connections
Telecontrol connections
Telecontrol relationships between the communications modules involved are required for
telecontrol communication. Depending on the module type and the firmware version, you
perform the configuration in the following parameter groups:
● "Partner stations" parameter group
or
● "Network data" editor
Configuration in the "Partner stations" parameter group
For S7-1200 telecontrol CPs up to V2.1, which only function as stations, the relationships to
the master station or to the master are configured in the "Partner stations" parameter group.
This is where you define the communication partners of the CPs.
All other settings required for communication with the master station are taken from the other
configuration data of the CPs and do not have to be specially configured for the connections.
Configuration in the "Network data" editor
For all other telecontrol modules that do not fall into the above group, you need to configure
telecontrol connections in the "Network data" editor.
The "Network data" editor is used for the following modules:
● CP 1243-1 / CP 1243-8 IRC as of firmware V3.1
CP 1542SP-1 IRC as of firmware V2.0
TIM 1531 IRC as of firmware V2.0
TIM 3V-IE DNP3 / TIM 4R-IE DNP3 as of firmware V3.2
86
Configuration Manual, 11/2018, C79000-G8976-C508-01
Configuration - DNP3