Siemens SIMATIC TeleControl DNP3 Configuration Manual page 106

Configuration
3.20 Configuring data points
● Sorting objects
If you click briefly with the left mouse button on a column header, you can sort the objects
of the table in ascending or descending order according to the entries in this column. The
sorting is indicated by an arrow in the column header.
After sorting in descending order of a column the sorting can be turned off by clicking on
the column header again.
● Adapting the column width
You can reach this function with the following actions:
– Using the shortcut menu that opens when you click on a column header with the right
– If you move the cursor close to the limit of a column header, the following symbol
● Showing / hiding columns
You call this function using the shortcut menu that opens when you click on a column
header with the right mouse key.
Copying data points and messages
As with many other programs, you can copy and paste objects in the data point or message
editor.
If you right-click in the row of an object in the table, you can access this function from the
shortcut menu:
● Cut
● Copy
● Paste
You can paste cut or copied objects within the table or in the first free row below the
table.
You can also paste cut or copied objects into tables of other communications modules of
the same type and with the same telecontrol protocol.
● Delete
If you hold down the <Ctrl> key, you can select several rows that are not contiguous.
With the <Shift> key pressed, you can select the beginning and the end of a contiguous
area.
106
mouse key.
"Optimize width", "Optimize width of all columns"
appears:
When it does, click immediately on the column header. The column width adapts itself
to the broadest entry in this column.
Configuration Manual, 11/2018, C79000-G8976-C508-01
Configuration - DNP3