Siemens SIMATIC TeleControl DNP3 Configuration Manual page 134

Diagnostics
4.1 Diagnostics options
● Industrial Remote Communication
Here, you obtain WAN-specific information on the TIM module:
– Partner
– Data point list
– Protocol diagnostics
● Time
Specification of the current time in the module and the time source. Possibility to set the
time in the module.
Functions
You can run the following functions here:
● Firmware update
● Assign IP address
● Assign PROFINET device name
● Reset to factory settings
For information on the functions, refer to the section Maintenance (Page 155).
● SINAUT special diagnostics
For a description, see section SINAUT special diagnostics (Page 137).
Web server (WBM) of the TIM 1531 IRC
From a PC you can use HTTP/HTTPS to access the Web pages (WBM) of the TIM. The
WBM returns a variety of information.
For access to the content, refer to the section WBM of the TIM 1531 IRC (Page 167).
134
Here you will find address and configuration data of the partners, connection statistics
and additional diagnostics information. Click on a subscriber to display additional
information.
You will also find information on the partners in the WBM, see below.
Information on the data points such as configuration data, value, connection status
etc.
With this function, you can enable the logging of frames of the module and evaluate it
using the SINAUT engineering software.
With the function "Enable protocol trace", the frames received and sent by the module
are copied for several seconds.
With the function "Disable protocol trace", the logging is stopped and the data is
written to a logging file.
With the function "Save", you can save the log file on the engineering station.
To evaluate the file, you need to rename it to the format "*.7dt". You can decode and
analyze the renamed file using the TIM frame monitor of the SINAUT diagnostics tool.
Configuration Manual, 11/2018, C79000-G8976-C508-01
Configuration - DNP3