Toyota Celica 2005 Repair Manual page 7

IN−6
WRONG
WRONG
2005 CELICA (RM1131U)
INTRODUCTION
(k)
(l)
CORRECT
IN0253
CORRECT
IN0252
− REPAIR INSTRUCTIONS
Care must be taken when jacking up and supporting the
vehicle. Be sure to lift and support the vehicle at the prop-
er locations (See page IN−8).
Cancel the parking brake on the level place and
S
shift the transmission in Neutral (or N position).
When jacking up the front wheels of the vehicle at
S
first place stoppers behind the rear wheels.
When jacking up the rear wheels of the vehicle at
S
first place stoppers before the front wheels.
When either the front or rear wheels only should be
S
jacked up, set rigid racks and place stoppers in front
and behind the other wheels on the ground.
After the vehicle is jacked up, be sure to support it
S
on rigid racks . It is extremely dangerous to do any
work on a vehicle raised on a jack alone, even for
a small job that can be finished quickly.
Observe the following precautions to avoid damage to the
following parts:
(1) Do not open the cover or case of the ECU unless
absolutely necessary. (If the IC terminals are
touched, the IC may be destroyed by static electric-
ity.)
(2) To disconnect vacuum hoses, pull off the end, not
the middle of the hose.
(3) To pull apart electrical connectors, pull on the con-
nector itself, not the wires.
(4) Be careful not to drop electrical components, such
as sensors or relays. If they are dropped on a hard
floor, they should be replaced and not reused.
(5) When steam cleaning an engine, protect the elec-
tronic components, air filter and emission−related
components from water.
(6) Never use an impact wrench to remove or install
temperature switches or temperature sensors.
6