Backing up Images in Save Image Memory to SD
Memory Card
1.
Select "SAVE/READ" from the menu bar.
2.
Select "Save Image Memory".
Backup of Save image memory to a SD memory card cannot be executed during operations (in RUN
mode). Selecting "Save Image Memory" during operations displays a message. Select "YES" to stop the
operation.
3.
Specify a folder number of the SD memory card
to save.
00 to 99 are available.
Specifying it displays a confirming message.
If you specified the number where image data
already exists, the message to confirm overwriting
appears.
4.
Select "Yes".
After the saving is complete successfully, a message appears. Press the ENTER key to close.
Clearing Images of Save Image Memory
1.
Select "SAVE/READ" from the menu bar.
2.
Select "Clear Image Memory".
A confirming message appears.
3.
Select "Yes".
Clearing is executed.
4.16.4 Operation of Test Image Memory
The Test image memory (page 281, Image Memory map - 2) calls up images from the Save image memory or a
SD memory card in SETUP menu to set checkers and execute a test.
To operate the Test image memory, use Image Menu displayed by pressing the F1 key in SETUP menu.
Calling up to Test Image Memory
The images saved in the following three areas can be called up to the Test image memory.
Image memory:
Memory image in SD:
Test image in SD:
1.
Press the F1 key to display Image menu.
2.
Select "Read Image".
The window to select the reading source appears.
Read from the Save image memory of PV500.
Backup images in a SD memory card (folder = ¥Image¥Backup¥00-99)
Test images in a SD memory card (folder = ¥Image¥Backup¥Test)
287