Connecting Power To Xga Monitor - Panasonic PV500 User Manual

2.5.2 Connecting Power to XGA Monitor

Connect the power of 24 V DC to the terminal on the back side.
Use an insulated power supply with a built-in protection circuit as a power supply device to supply 24 V DC.
Rated voltage: 24 V DC
Operating voltage range: 21.6 to 26.4 V DC
Power consumption: 1A or less
Applicable Solderless Terminal
·
Terminal screws are M3.
·
Screw the terminal block with tightening torque of 0.8 Nm.
Failure to do so might damage to the product.
·
It is advisable to use solderless terminals to wire.
Use wires of 0.5 mm
Manufacturer
JST Mfg. Co., Ltd.
2 2
to 1.25 mm diameter if you do not use a solderless terminal.
Shape Model No.
R-type 1.25-MS3
A-type 1.25-B3A
R-type 2-MS3
A-type 2-N3A
Applicable wire
2 2
0.25 mm to 1.65 mm
2
1.04 to 2.63 mm
Tightening torque
0.5 to 0.6 N/m
31