Panasonic PV500 User Manual page 407

Print Screen
It is output into the place specified from "ENVIRONMENT" -> "Input/Output" -> "Print Screen" -> "Destination".
This command cannot specify the destination.
% P S
Send
Receive % P S
Error (ERROR 1 signal = ON)
% P S
Error code
200
265
Resetting Statistics Data
Resets statistics data and scan count.
Send % Q
% Q $
Receive
Error (ERROR 1 signal = ON)
% Q
Error code
200
Switch between Run/Stop
% R M ?
Send
Receive % R M $
Error (ERROR 1 signal = ON)
% R M
Error code
240
Example: Switches to Run.
Send
Receive
BCC CR
$ BCC(02) CR
! Error code (3-digit)
Operation is stopped
• No SD memory card is attached or cannot be accessed.
• Capacity of the SD memory card is used up.
• The SD memory card is write-protected.
• Ethernet communication cannot be established (with connection problems
such as cable unconnected or disconnection)
• Image Receiver is not activated or stopped.
BCC CR
BCC(50) CR
! Error code (3-digit)
Operation is stopped
BCC CR
? BCC CR
! Error code (3-digit)
• Specification of the parameter is wrong. (A number other than 0 and 1 was
specified.)
• PV500 sent a command in the following inoperable state.
- When selecting "TOOL" > "General", "Setting Help" or
"Update"
- When displaying SETUP menu when "Run Mode in SETUP
Menu" is set to "Not Available"
% R M 0 * * CR
% R M $ 0 2 E CR
BCC = 26 or **
BCC CR
BCC = 74 or **
BCC CR
? = 0 - 1 (0 = switch to RUN, 1 = switch to STOP)
? = 0 – 1 (0 = RUN, 1 = STOP)
BCC CR
405