Displaying General Output Setting Window
1.
Select "ENVIRONMENT" > "Input/Output"
from the menu bar.
2.
Select "General Output" in "Input/Output"
setting window.
Selecting Destination of General Purpose
Communication and (General) Output data
1.
Select a data destination in "Destination".
You can select only one type as a destination.
Select "General Purpose Comm." for "Protocol". Refer to page 417 about PLC communication.
2.
To output Date and Time, select "Output",
For "SD Card" setting of destination, setting "Date and Time" to "Output" adds "Time" to output data.
Date and Time cannot be added when the destination is "Serial (COM.0)".
3.
To output Scan Count/ Total Judgement/ Judgement/ Numerical Calculation, select "Output".
4.
To output BCC (block check code), select "Output".
BCC cannot be added when the destination is "SD Card".
277