Ladder Send E-Mail Settings - Panasonic FP2 ET-LAN Technical Manual

11.8.2 Ladder Send E-mail Settings

Before sending e-mails using the ladder program, be sure to confirm that the settings as shown below
are registered using the setup tool (Configurator ET).
E-mail address(es) specified for the destination address(es) ("To", "Cc", and "Bcc")
-
A message specified in Message No.
-
A signature specified in Signature No.
- Ladder send e-mail setting area (Bank: 10H)
Address Name
000H Destination address 1
(For "To")
(Address Nos. 1 to 16)
001H Destination address 2
(For "To")
(Address Nos. 17 to 32)
002H Destination address 1
(For "Cc")
(Address Nos. 1 to 16)
003H Destination address 2
(For "Cc")
(Address Nos. 17 to 32)
004H Destination address 1
(For "Bcc")
(Address Nos. 1 to 16)
005H Destination address 2
(For "Bcc")
(Address Nos. 17 to 32)
006H Message No.
007H Signature No.
008H
009H
00AH
00BH Reserved (Used in the system.)
If necessary, write "0000H".
00CH
00DH
00EH
00FH
Default Setting value/Explanation
0000H Default: 0 to FFFFH
Using the ladder program, Nos. of the destination addresses
(for "To", "Cc", and "Bcc") which are registered in the Address
Book by means of Configurator ET can be specified. In this
0000H
process, bit data is used.
Example:
0000H
When sending e-mails to the address Nos. 1 and 6 registered in
the Address Book:
0000H
When Bit 0 and Bit 5 of Destination address 1 (For "To",
Address: 000H) in the ladder e-mail setting area (Bank: 10H)
are set to "1", e-mail address Nos. 1 and 6 registered in the
0000H
Address Book are specified as the destination
0000H
▪ To send e-mails using the ladder program, specify the value
other than "0H" for either Destination address 1 (For "To") or
Destination address 2 (For "To").
▪ This setting is not required for the destination addresses "Cc"
and "Bcc".
0000H Default : 0H
Setting value: 1 H to the numbers that are registered as e-mail
messages using Configurator ET
・ The e-mail message that you wish to send using the ladder
program is specified.
・ The e-mail message No. registered using Configurator ET is
specified. If the No. which is not registered is specified, e-mail
message cannot be sent.
0000H Default: 0H
Setting value: 0 to 5H
・ The signature which is attached to the e-mail message using
the ladder program is specified.
The fixed signature is determined as No. 5. Other signatures
than the fixed one registered using Configurator ET are
determined as Nos. 1, 2, 3, and 4 from the first one. When "0" is
specified, a signature is not attached to the e-mail. If the value
other than 0 to 5H is specified, e-mails cannot be sent.
addresses.
11-17