Panasonic FP2 ET-LAN Technical Manual page 55

Address Name
TCP ULP
(packet
20AH
existence
duration)
TCP
20BH zero-window
timer value
TCT
20CH re-transmission
timer value
TCP
20DH closed timer
value
IP
20EH reassembling
timer value
Reserved
20FH (Used by the
system.)
Default
value
Setting time = [Setting value (1 to FFFFH)] x 2 seconds
000FH
- With TCP, this specifies the time that a packet exists
[30 seconds]
when data transmission, etc. is carried out.
Setting time = [Setting value (1 to FFFFH)] x 2 seconds
0005H - With TCP, this specifies the time until the receiver
[10 seconds] window size check packet is re-sent when the receive
window size of the other node becomes 0.
Setting time = [Setting value (1 to FFFFH)] x 2 seconds
0005H - With TCP, this specifies the time until data is re-sent if
[10 seconds] ACK is not sent by the other node, when data
transmission, etc. is carried out.
Setting time = [Setting value (1 to FFFFH)] x 2 seconds
- This specifies the time waited until open processing is
0001H
carried out when the same port is being re-opened,
[2 seconds]
when TCP close processing is done by the source
node.
Setting time = [Setting value (1 to FFFFH)] x 2 seconds
000FH
- This specifies the time waited for the next portion of
[30 seconds]
data when data split by the IP is being received.
- If any value is written, it should be 0000H.
Setting value and explanation
5-7