Panasonic FP2 ET-LAN Technical Manual page 279

Ladder send e-mail setting area (Bank: 10H)
Address Name
000H Destination address 1
(For "To")
(Address Nos. 1 to 17)
001H Destination address 2
(For "To")
(Address Nos. 17 to 32)
002H Destination address1
(For "Cc")
(Address Nos. 1 to 16)
003H Destination address 2
(For "Cc")
(Address Nos. 17 to 32)
004H Destination address 1
(For "Bcc")
(Address Nos. 1 to 16)
005H Destination address 2
(For "Bcc")
(Address Nos. 17 to 32)
006H Message No.
007H Signature No.
008H Reserved (Used in the system.)
If necessary, write "0000H".
009H
00AH
00BH
00CH
00DH
00EH
00FH
Default Set value/Explanation
0000H [Default] 0 to FFFFH
Nos. of the destination addresses (for "To", "Cc", and "Bcc")
which are registered in the Address Book by means of
Configurator ET can be specified. In this process, bit data is
0000H
used.
Example:
0000H
When sending e-mails to the Nos. 1 and 6 addresses registered
in the Address Book:
Destination address 1 (For "To", Address: 000H)
0000H
0000H
- To send e-mails using the ladder program, set the default to
the value other than "0H" for either Destination address 1 (For
0000H
"To") or Destination address 2 (For "To").
- This setting is not required for the destination addresses "Cc"
and "Bcc".
0000H [Default] 0H
[Set value] 1H to the numbers that are registered as e-mail
messages using Configurator ET
- The e-mail message that you wish to send using the ladder
program is specified.
- The e-mail message No. registered using Configurator ET is
specified.
0000H [Default] 0H
[Set value] 0 to 5H
- The signature which is attached to the e-mail message using
the ladder program is specified.
- The fixed signature is determined as No. 5. Other signatures
than the fixed one registered using Configurator ET are
determined as Nos.1, 2, 3, and 4 from the first one. When "0"
is specified, a signature is not attached to the e-mail.
15-17