Changing The Power On Configuration - IBM 6400i Setup Manual

Step Key
10.
Stop

Changing The Power On Configuration

Configuration
Management
Recall Save Current
Custom Set Values
Name
Custom Sets
When you power on the printer for the first time, it loads the factory default
configuration. If you power the printer off and then back on, the printer will
load the designated power-on configuration (which is set to Factory Default by
default). It will not load the last saved configuration.
The Change Power On Set option allows you to select a custom set of
configuration values as the power-on configuration. The example on the
following page shows how to select Custom Set 1 as the power-on
configuration.
NOTE: Be sure you define and save a custom set before attempting to use it
LCD Results
READY
Delete
Custom Set
Reset
Custom Set
Names
as the Power On Custom Set. Otherwise, the current Power On
Custom Set remains selected and the following operator panel
message is displayed:
042 CUSTOM SET DOES NOT EXIST
SAVE FIRST
For example, if you attempt to change the Power On Custom Set
from Custom Set 1 to Custom Set 4, and if Custom Set 4 does not
exist, Custom Set 1 remains the Power On Custom Set.
Changing The Power On Configuration
Entering Program Mode
Places the printer in READY
mode, prepared for normal
operation.
* = Factory Default
Change Protect
Power On Set Custom Sets
Factory Default*
Custom Set 1
Custom Set 2
Custom Set 3
Custom Set 4
Custom/Preloaded Set 5
Custom/Preloaded Set 6
Custom/Preloaded Set 7
Custom/Preloaded Set 8
Notes
Print Custom
Set Values
99