Table of Contents
Advertisement
Print Quality
NOTE: When using bold or emphasized printing, the printer prints two dots
instead of one to produce the desired effect. This does not affect
characters per inch.
This parameter specifies the density (quality) of printing:
•
DP Quality (the default)
•
Near Letter Quality
•
OCR A
•
OCR B
•
Draft
•
NLQ Sans Serif
NOTE: Receipt of a data stream control sequence that changes the print
quality overrides the print quality specified via the operator panel.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A/
OCR B are the only available values for this parameter. If a different print
quality value is desired, the print language must be changed first.
Print Character Table
This parameter prints out a table of the current interface character set.
Print Attributes
The PRINT ATTRIBUTES parameter is used to determine character and
page formatting.
Proportional Spacing
Uses proportional spacing for text data when enabled.
•
Disable (the default)
•
Enable. Uses proportional spacing for text data.
NOTE: Proportional spacing is only supported in 10 CPI. Therefore, you must
select 10 CPI, or proportional spacing will be ignored.
Italic Print
Prints text in italics, when enabled. Both a forward and backwards slanting
italic are available.
•
Disable (the default)
•
Forward Slant. Uses italic print that slants forward.
•
Backward Slant. Uses italic print that slants backward.
Print Format Menu
239
Advertisement
Table of Contents
