IBM 6400i Setup Manual page 190

Chapter 4
IPDS Feature
Print Language (TCP/IP IPDS)
PRINT LANGUAGE specifies the set of print languages used by the printer.
Refer to the previous page for print language menus.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A and
OCR B are the only available values for this parameter. If a different print
quality value is desired, the print language must be changed first.
NOTE: This configuration value applies only to IPDS on the Ethernet. For
Undefined Character Substitution (TCP/IP IPDS)
Undefined Character Substitution specifies the replacement character to print
in place of any unprintable character that is received by the host.
•
60 (the default)
•
40 – FE
NOTE: This configuration value applies only to IPDS on the Ethernet. For
Maximum Printable Width (TCP/IP IPDS)
Maximum Printable Width sets the maximum width of the printer when using
an IPDS host interface.
•
13.2 Inches (the default)
•
13.6 Inches
NOTE: This configuration value applies only to IPDS on the Ethernet. For
190
Coax or Twinax IPDS, use the corresponding configuration value in
the Coax or Twinax Interface menu.
Coax or Twinax IPDS, use the corresponding configuration value in
the Coax or Twinax Interface menu.
Coax or Twinax IPDS, use the corresponding configuration value in
the Coax or Twinax Interface menu.