Changing The Paper Exit Location (Pedestal Models Only); Setting Top Paper Exit - IBM 6400i Setup Manual

Changing the Paper Exit Location
(Pedestal Models Only)
On pedestal model printers you can select whether the paper exits from the
rear or from the top of the printer. Normally, you should select the top exit only
when you will be tearing the forms from the printer and using them soon after
printing. Forms will not stack in top exit mode.

Setting Top Paper Exit

1. Press Stop to place the printer in NOT READY state.
If there is paper in the printer, unload the paper, then continue with step 2 of
this procedure.
Figure 21. Underview of the Right, Rear Pedestal Cover Showing Adjustment of the Hinge
2. Open the printer cover.
3. Loosen the two hinge adjustment thumbscrews.
4. Slide the cover toward the rear of the printer until it stops.
Thumbscrew
Thumbscrews
Setting Top Paper Exit
49