Table of Contents
Advertisement
Chapter
4
Network Setup Menu
Job Control
The job control mode has three options:
•
Standard (the default). The NIC waits for the printer to finish receiving the
current job before sending another job. The status line shows "done"
when the job is completely received by the NIC. This is default.
•
Enhanced. The NIC waits for the printer to finish receiving the current job
before sending another job. The status line shows "done" when the job is
fully printed.
•
Off. No job synchronization between the NIC and the printer.
Ethernet Hotport
Gives the printer the ability to handle multiple data streams simultaneously. It
allows the printer to service hosts attached to the serial, ethernet, and either
the coax or twinax ports as if they were the only interface connected.
Timeout
This is the value used by the printer to time out from the current port and
check the other ports for data to print. When the printer has not received data
from the host after a certain period of time, it needs to Timeout in order to
service the other ports.
•
10 Sec (the default)
•
10 Sec - 60 Sec
164
Advertisement
Table of Contents
