Table of Contents
Advertisement
Appendix D
Attaching Printer to zSeries Systems
Step 2 - VTAM Definition
* The following entry should be placed in the VTAM MODE TABLE specified
above or another of your choice.
6400DSER MODEENT LOGMODE=6400DSER
Step 3 - JES2 Definition
This definition is not required if you are using VPS and using U1 - U9999 as
the printer ID.
RMT1
LUTYPE3,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,NOCM
PC ,
R1.PR1
CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,F,T/
C,P),
DESTID NAME=P6400,DEST=R1
Step 4 - Define to CICS or another application program
Refer to the vendor documentation for defining a DSE printer to the program
for its use. Host system commands to change printer settings are not
supported in DSE mode.
Step 5 - Printer Settings
It is recommended that the following printer settings be changed from factory
default settings:
•
Printer Control => Interface Selection => Coax
•
Coax Interface => Format Control => Enable
•
Coax Interface => Early Print Complete => Enable
Since the host controls are not supported, the printer settings for CPI, LPI,
and others should be set at the printer. See page Setup Guide.
322
FMPROF=X'03',TSPROF=X'03',PRIPROT=X'B1',
SECPROT=X'90',COMPROT=X'3080',RUSIZES=X'87C6',
PSERVIC=X'038000000000185018507F00'.
PSNDPAC=X'01',SRCVPAC=X'01'
SETUPHDR,CONSOLE (SETUPHDR=PDIR JES2 V3)
CKPTPAGE=30
Advertisement
Table of Contents
