IBM 6400i Setup Manual page 142

Chapter 4
5250 Interface Menu
Lead-In Characters
The Lead-In Character commands must have a start and end code. Set 1 is
the factory default. Three sets (each containing a start and end code) are
available:
•
•
•
•
User Defined Codes
•
•
•
The codes have a range of x'40' - x'FF'.
Alternate Set 80 - 9F
This selection determines if ASCII codes 80 hex through 9F hex will be used
as control codes or printed as standard printable characters.
•
Printable (the default). Prints the alternate set as standard characters
•
Control Code. Selects the alternate set to be used as printer control
codes.
Undefined Character Reporting
UNDEFINED CHARACTER REPORTING allows overriding of the host
setting of the SGEA (Set Graphic Error Action) command. For more
information about the SGEA command, refer to the 6400 Coax/Twinax
Programmer's Reference Manual.
•
Enable (the default). The host setting for the SGEA and is used by the
printer. If the SGEA command is requested to stop on graphic errors, the
printer will stop when a graphic error is detected.
•
Disable. Ignores the SGEA command from the host. The printer does not
stop when an error is detected; instead, it substitutes the character
selected in the "UNDEFINED CHARACTER SUBSTITUTION" menu
entry.
142
Set 1: start code = <% (the default)
end code = >
¬¬
Set 2: start code =
end code = $
Set 3: start code = _%
end code = _
User Defined
Start Code 2: 5F (the default)
Start Code 1: 5F (the default)
Stop Code: 5B (the default)