IBM 6400i Setup Manual page 120

Chapter 4
Twinax Interface Menu
World Trade
The 5225 emulation has a multinational character set that serves as a base
for 14 world trade character set assortments. They are shown in the 6400
Coax/Twinax Programmer's Reference Manual.
You can configure the printer to use the Standard Character Set so the printer
contains the IBM World Trade character set, such as the Austria/Germany
character set. Or, you can select Extended Character Set and use the
multinational character set as a base with the selected world trade character
set overlaid.
•
Standard Character Set (the default)
•
Extended Character Set.
Cancel Buffers
CANCEL BUFFERS has the following options:
•
Enable (the default). Cancels all buffers when a job is put on hold from
the host or the Cancel key is pressed.
•
Disable. Clears the twinax internal buffer, not the print engine buffers,
when a job is put on hold from the host or the Cancel key is pressed.
Early Print Complete
Early Print Complete allows the printer to send Print Complete status to the
host before the printer is actually done printing all data. Early Print Complete
is only available if the IPDS feature is installed.
•
Disable (the default). Means the printer will suppress the Early Print
Complete response until all printing is complete.
•
Enable. Means the printer will send an acknowledgement to the host
when it is able to accept more data.
NOTE: When an Early Print Complete is enabled and an error occurs, the
120
data in the printer will remain in the buffer (regardless of the setting of
the Cancel Buffer option). It is recommended that local procedures be
followed to recover from the error.
Do not select Early Print Complete while a print job is in progress. If
this is done you will need to restart the printer.