3．Connection; Connection With Power Source Input Terminal - Unipulse F370 Operation Manual

3. CONNECTION

3-1. Connection with Power Source Input Terminal

AC spec.
Connect AC power code attached to the terminal.
Voltage input : AC100V - 240V Frequency : 50/ 60Hz
DC spec. (Depending on the request at the time of order)
Connect the positive (+) side of the power source to the red screw side of the terminal
block on the back of the F370, and its negative (-) side to the black screw side. The input
voltage is 12V - 24V DC.
AC IN
L
N
F.G.
CAUTION
Check the wiring precisely before power source is turned on.
DC IN
＋
－
F.G.
CAUTION
Be aware that the voltage drops depending on the wire thickness and
length. Also, never input an AC power source. Doing so will cause a
failure.
3.CONNECTION
（Black）
（White)
（Green)
（Red）
（Black)
9