Table of Contents
Advertisement
6. Save program and exit. When the display flashes all operation keys,
press [Enter] to save the program and exit the programming mode. The
pipette emits a triple beep tone to signal the end of the programming
sequence. The first step in the program is displayed. "Run" is displayed in
the lower left corner to indicate that the new program is ready to be run. Go
to Section C.2.6 for Reviewing the Program, or Section C.4 for Operating
Procedures.
C.2.3 Storing a Program
To create and store programs in the Equalizer pipette:
1. Select the program number by pressing the [Prog] key, then press the [Vol]
key until the desired program number (P1-P5) is displayed.
2. Press and hold the [Prog] key, while simultaneously pressing the Special
Function key to enter the programming mode. The prompt "Prog" will
appear on the display.
3. Begin entering your new program (refer to Section C.2.2, Entering a
Program in Open Programming Mode, for instructions).
NOTE: When programming mode is active, the Speed Setting and Beep Tone
symbols will blink.
Upon pressing the [Enter] key to save and exit the program mode, the new
program will be stored under the selected program number.
The program number will be displayed for two seconds. (The first step of the
newly written program is displayed). This program is ready to be run.
C.2.4 Program Recall
To recall a stored program:
1. Press the [Prog] key, then the [Vol] key to select the desired program
number.
2. Press the [Enter] key to activate the displayed program.
Programming and Operation
17
Advertisement
Table of Contents
