Table of Contents
Advertisement
Updating Firmware
The firmware upgrade utility provides a way to replace the firmware that is coded on the
control board of the switcher without taking the switcher out of service.
NOTE: Upgrading the firmware does not overwrite the current configuration or
presets.
Update the switcher firmware as follows:
1.
Perform steps 1 through 7 of
firmware upgrade from the Extron website.
2.
Click
Run
1 on the next page). The PC extracts the firmware update received from the Extron
website and starts the Extron Installation Program to extract the firmware file.
3.
Click
Next
files and places them in a folder identified in the InstallShield Wizard dialog box.
ATTENTION:
•
•
NOTES:
•
•
Installing the
in the
and
File Download
in the
Firmware Upgrade
The firmware file must have an .s19 extension. Other file types can cause the
switcher to stop functioning.
Le firmware doit avoir une extension .S19. D'autres types de fichiers peuvent
nuire au fonctionnement de l'émetteur.
Note the folder to which the firmware file is saved. When downloaded
from the Extron website, the firmware is placed in a subfolder of:
•
Windows 7 or Windows 8:
•
Older versions:
\
C:
Program Files\Extron\Firmware
The original factory-installed firmware is permanently available on the matrix
switcher. If the attempted firmware upload fails, the switcher reverts to the
factory-installed firmware.
FOX Matrix 320x and FOX Matrix 14400 • Matrix Software
Software, on page 37, to download the
dialog boxes (see
Security Warning
dialog box (
2 ). The program extracts the firmware
\
C:
Program Files (x86)\Extron\Firmware
figure
24,
.
.
48
Advertisement
Table of Contents
