Using The Matrix Switchers Control Program; Starting The Program - Extron electronics FOX Matrix 320x User Manual

Using the Matrix Switchers Control Program

Many items found in the Matrix Switchers Control Program are also accessible under SIS
control (see

Starting the Program

1.
2.
3.
Programming Guide, beginning on page 20).
To run the Matrix Switchers Control Program, click
> >
Start Programs Extron Electronics
MATRIX Switcher + Control Pgm
The
Comm Port Selection
Figure 18. Comm Port Selection Dialog Box
Choose either the comm port that is connected to one of the serial ports of the
switcher, , or
IP [LAN] Emulate
If you selected a comm port, check the baud rate displayed in the comm port
•
selection dialog box.
NOTE: If you need to change the baud rate, click the Baud
button and double-click the desired baud rate. The default
is .
9600
Click . The Extron Matrix Switchers Control Program window appears, displaying
OK
the current configuration of the attached matrix (see
page 42). Proceed to step 4.
• If you selected
IP [LAN]
• If you selected
Emulate
If you selected in step 2, the
IP [LAN]
(see figure 19).
Figure 19. IP Connection Dialog Box
FOX Matrix 320x and FOX Matrix 14400 • Matrix Software
>
Matrix Switchers
.
dialog box appears (see figure 18).
.
, click and proceed to step 3.
OK
, click and see Using Emulation Mode
OK
IP Connection
>
figure 20 and figure 21 on
on page 56.
dialog box appears
40