Table of Contents
Advertisement
Ethernet Connection
This section provides a high level discussion of the Ethernet connection to the switcher and
a primer on the subject of subnetting. Topics that are covered, include:
•
•
Ethernet Link
The rear panel Ethernet connector on the FOX matrix switcher can be connected to an
Ethernet LAN or WAN. This connection makes SIS control of the switcher possible using a
computer connected to the same LAN.
Ethernet Connection
The Ethernet cable can be terminated as a straight-through cable or a crossover cable and
must be properly terminated for your application (see
•
•
Default IP Address
To access the FOX matrix switcher via the LAN port, you need the IP address of the
switcher. If the address has been changed to an address comprised of words and
characters, you can determine the actual numeric IP address using the ping utility. If the
address has not been changed, the factory-specified default is 192.168.254.254.
Ping can also be used to test the Ethernet link to the FOX matrix switcher.
Ethernet Link
Subnetting — A Primer
Crossover cable — Direct connection between the computer and the
FOX matrix switcher
Patch (straight-through) cable — Connection of the FOX matrix switcher to an
Ethernet LAN
FOX Matrix 320x and FOX Matrix 14400 • Ethernet Connection
figure 10
on page 14).
82
82
Advertisement
Table of Contents
Need help?
Do you have a question about the FOX Matrix 320x and is the answer not in the manual?
Questions and answers