Table of Contents
Advertisement
Reset Operations
The rear panel
sake of comparison with an Extron IPL product). The
pointed stylus, ballpoint pen, or small screwdriver to access it.
See the following table for a summary of the modes.
ATTENTION:
NOTE: The reset modes listed below close all open IP and Telnet connections and close
Mode
Activation
1
Hold down the recessed
while applying power to the switcher.
NOTE: After a mode 1 reset is
performed, update the switcher
firmware to the latest version. Do
not operate the switcher firmware
version that results from the
mode 1 reset. If you want to use
the factory default firmware, you
must upload that version again
(see
Updating firmware
page 48 or details on uploading
firmware).
3
Hold the
Reset
button for approximately
3 seconds, until the Reset LED blinks once,
then momentarily press
Reset
1 second.
4
Reset
Hold the
button for approximately
6 seconds, until the Reset LED blinks
twice (once at 3 seconds and again at
6 seconds). Then momentarily press
Reset
within 1 second.
button initiates four levels of resets (numbered 1, 3, 4, and 5 for the
Reset
•
Review the reset modes carefully. Using the wrong reset mode may result in
unintended loss of flash memory programming, port reassignment, or a controller
reboot.
•
Étudier de près les différents modes de réinitialisation. Appliquer le mauvais mode
de réinitialisation peut causer une perte inattendue de la programmation de la
mémoire flash, une reconfiguration des ports ou une réinitialisation du contrôleur.
all sockets. Also, the following modes are separate functions, not a continuation from
mode 1 to mode 5.
Reset Mode Comparison and Summary
Reset
The switcher reverts to the factory default firmware.
button
Event scripting does not start if the switcher is powered on in
this mode. All user files and settings, such as IP settings, are
maintained.
NOTE: If you do not want to update firmware, or you
performed a mode 1 reset by mistake, cycle power
to the switcher to return to the firmware version that
was running before the mode 1 reset. Use the
0Q
(Query controller firmware version) SIS command
on page 31 to confirm that the factory default
firmware is no longer running (look for the asterisk [*]
on
following the version number).
Mode 3 turns events on or off. During resetting, the
Reset LED blinks two times if events are starting, three times if
events are stopping.
within
Mode 4:
•
Enables ARP capability.
•
Sets the IP address to the factory default.
Sets the subnet address to the factory default.
•
•
Sets the gateway address to the factory default.
•
Sets port mapping to the factory default.
•
Turns DHCP off.
•
Turns events off.
The Reset LED blinks four times in succession during the reset.
button is recessed, so use a
Reset
Result
FOX Matrix 320x and FOX Matrix 14400 • Installation
Purpose and Notes
Use mode 1 to return
the switcher to the
factory default firmware
version if incompatibility
issues arise with
user-loaded firmware.
Mode 3 is useful for
troubleshooting.
Mode 4 enables you
to set IP address
information using ARP
and the MAC address.
18
Advertisement
Table of Contents
