Removing The Folding Roller - Canon Staple Finisher-AA1 Service Manual

[1]
[2]
4. Remove the swing roller (rear)[1] and remove the
gear [2].
NOTE:
Swing roller (front) is not disassembled. (all-in-one with the
shaft)
CAUTION:
The paddle may remove by the installation/removal
work of the swing roller. Check that the paddle is
installed properly.
• Insert the claw of the paddle [1] into the groove [2].
• Align the paddle end face [3] with the shaft end
face [4].
[2]
[3]
[4]
[1]
[1]
[2]
[2]
[1]
[1]
[2]
[2]
[3]
[1]
[4]
[1]
4. Parts Replacement and Cleaning

Removing the Folding Roller

■ Preparation
1. Remove the saddle
Unit" on page 105
2. Remove the saddle stitcher controller PCB.
" Removing the Saddle Stitcher Controller PCB
(PCB201)" on page 118
■ Procedure
1. Remove the PCB holder[1].
• 4 connectors [2]
• 2 screws [3]
4x
2x
[1]
[3]
2. Remove the saddle upper guide [1].
• 2 screws [2]
• 2 insertion joints [3]
2x
3. Remove the rail stay [1].
• 4 screws [2]
136
unit." Removing the Saddle
[2]
[2]
[2]
[2]
[1]
[3]
[3]