Removing The Processing Tray - Canon Staple Finisher-AA1 Service Manual

Removing the Processing
Tray
■ Preparation
1. Lower the stack tray.
2. Remove the stack tray.
" Removing the Stack Tray" on page 96
3. Remove the grate-shaped lower guide.
" Removing the Grate-Shaped Lower Guide" on page
96
4. Remove the side covers (front and rear) [1] [2].
• 1 screw [3] each
2x
[3]
[1]
■ Procedure
1. Remove the connectors.
• 3 connectors [1]
• 1 wire saddle [2]
3x
[2]
[2]
1x
[1]
4. Parts Replacement and Cleaning
2. Remove the 1 belt [1], 1 clip [2], and 1 shaft support
[3].
[1]
3. Remove the area sensor unit [1].
• 1 screw [2]
• 1 connector [3]
1x
1x
4. Remove the processing tray [1].
• 2 screws [2]
102
[3] [2]
[1]
[3]
[2]