Canon Staple Finisher-AA1 Service Manual page 152

Items
Adjusting the delivery speed at the
staple mode
Adjusting the delivery speed of the
escape tray
Adjusting the binding pressure at
the staple-free binding mode
Adjusting the binding position for
the front/rear direction at the sta-
plefree binding mode
Adjusting the height of the return
belt 1
Adjusting the height of the return
belt 2
Adjusting the height of the return
belt 3
Adjusting the front/rear staple posi-
tion at the manual staple mode
Adjusting the punch hole position in
the horizontal registration direction
Adjusting the punch hole position in
feed direction
■ Operation and inspection items
Items
Reading the backup data from the fin-
isher controller PCB
Writing the backup data from the fin-
isher controller PCB
Clearing the RAM data of the finisher
controller PCB
Service Mode
(SORTER > AD-
JUST)
STP-SPD When the paper stacking at staple mode or
staple-free binding mode is misalignment.
ESC1-SPD When the paper stacking to the escape tray
is misalignment.
FR-ST-PS Upon user's request (When changing the
binding pressure).
FR-STP-Y When the binding position in front/rear di-
rection is displaced at the staple-free bind-
ing mode.
RBLT-PRS When the paper alignment position is irreg-
ular.
RBLT-PS2 When the misalignment of paper stack oc-
curs during alignment operation on the pro-
cessing tray.
RBLT-PS3 When the misalignment of paper stack oc-
curs during alignment operation on the pro-
cessing tray.
MSTP-2P When the staple position for front/rear di-
rection is displaced at the manual staple
mode.
PNCH-Y When the punch hole is misaligned in the
horizontal registration direction.
PNCH-X When the punch hole is displaced in feed
direction
Service Mode (SORT-
ER > FUNCTION)
FIN-BK-R When replacing the finisher controller
PCB.
FIN-BK-W When replacing the finisher controller
PCB.
FIN-CON When clearing the RAM data (excluding
the counter values) of the finisher con-
troller PCB
144
Use case
Use case
5. Adjustment
Remarks
- When the value is decreased,
the productivity is decreased.
- When the buffer operation is
performed, delivery speed
does not change. (The buffer
operation is the operation to
deliver the stacking paper on
the processing tray). The
ON/OFF of buffer operation is
set by BUFF-SW.
The life of staple-free binding
unit becomes shorter when in-
creasing the setting value.
The height of Return Belt dur-
ing the paper alignment on the
processing tray is the total of
setting values of RBLT-PS2
and PBLT-PS3, so adjust
again the setting value of
RBLT-PS2 if necessary when
changing the setting value of
RBLT-PS3.
- When the setting of "PUN-Y-
SW" is 0, the adjustable range
is from -3 to 15.
- This mode is available when
the puncher unit has been in-
stalled.
- When setting the punch
mode to the precision priority,
this adjustment cannot be exe-
cuted.
- This mode is available when
the puncher unit has been in-
stalled.
Remarks
- Output the service mode
setting values by P-PRINT
before execution. After exe-
cution, enter necessary set-
ting values.
- The RAM data is cleared
after the main power switch
is turned OFF/ON.