Canon Staple Finisher-AA1 Service Manual page 174

<Procedure of adjustment>
NOTE:
After the setting value is changed, write the changed value in the service label.
1. Adjust the saddle alignment plate position by the following service modes.
• SORTER > ADJUST > SDL-ALG
Adjustment range: -20 to 20 (Unit: 0.1mm)
As the value is incremented by 1, the alignment width is increased by 0.1 mm.
+: The width of the adjustment plate becomes narrow.
-: The width of the adjustment plate becomes wide.
NOTE:
In the case the misalignment occurs after adjusting the Saddle Alignment Plate Position. Check the following items, and adjust
again.
• Check the connection between finisher and host machine.
• Adjust side registration of host machine cassette and/or paper deck. Refer to the host machine service manual.
-
+
Alignment Plate
Feed Direction
166
-
+
Alignment Plate
5. Adjustment