Removing the Saddle Unit
■ Preparation
1. Pull out the saddle unit (service position).
“ Pulling Out the Saddle Unit (Service Position)” on page
131
2. Remove the lower front cover.
“ Removing the Lower Front Cover” on page 94
■ Procedure
1. Remove the saddle PCB cover [1].
• 2 screws [2]
[2]
[1]
2x
2. Remove the harness.
• 2 connectors [1]
• 2 wire saddles [2]
• 1screws [3]
2x
[3]
2x
1x
[1]
[2]
[1]
4. Parts Replacement and Cleaning
3. Remove the saddle unit [1].
• 2 screws [2]
• 4 hangers [3]
[3]
[3]
[1]
2x
[3]
[2]
[2]
[3]
CAUTION:
Hold specific parts to remove the Saddle Unit as shown
in the figure or there is a possibility of breakage when
holding other parts.
NOTE:
Since the saddle unit is not stored due to come in contact
with the front cover. When installing the saddle unit, be
sure to open the front cover.
Page 105