Canon Staple Finisher-AA1 Service Manual page 180

1. Adjust the saddle stitch position by the following service modes.
• SORTER > ADJUST > SDL-STP
NOTE:
To adjust the staple position of Saddle Stitcher (when using the thin paper; the paper that the paper weight is less than 64 g/m2).
To adjust the staple position of Saddle Stitcher (when using the thin paper; the paper that the paper weight is less than 64 g/m2),
adjust the saddle stitch position by the following service mode.
SORTER > ADJUST > SDL-STP2
Feed Direction
Adjustment range: -20 to 20 (Unit: 0.1mm)
As the value is incremented by 1, the staple position moves by 0.1mm.
+: The staple position moves toward the left at open page of the book
-: The staple position moves toward the right at open page of the book
-
+
B
172
Stapling Position
B
5. Adjustment