Canon Staple Finisher-AA1 Service Manual page 162

■ Adjusting Delivery of Staple Stack
<Use case>
• When the paper displacement occurs on the 1st to 2nd sheets or 2nd to 3rd sheets of buffered paper.
<Procedure of adjustment>
NOTE:
After the setting value is changed, write the changed value in the service label.
1. Adjust the paper displacement occurs by the following service modes.
• When the paper displacement occurs on the 1st to 2nd sheets of buffered paper.
SORTER > ADJUST > BFF-SFT
• When the paper displacement occurs on the 2nd to 3rd sheets of buffered paper.
SORTER > ADJUST > BFF-SFT2
Adjustment range: -60 to 60 (Unit: 0.1mm)
As the value is incremented by 1, the paper position moves by 0.1mm.
+ : The 1st sheet of buffered paper shifts toward the inlet side
- : The 1st sheet of buffered paper shifts toward the delivery side
Feed Direction
Feed Direction
154
Feed Direction
3rd sheet
2nd sheet
1st sheet
-
-
5. Adjustment