Canon Staple Finisher-AA1 Service Manual page 189

If backup operation has been performed
1. Write the backup data to the new PCB in the host machine's service mode.
SORTER > FUNCTION > FIN-BK-W
2. Turn the main power of the host machine off and then on.
If backup operation has not been performed
1. Set the SW1 keys as shown below and press the SW2.
2. Set all SW1 keys set to OFF.
3. Based on the output setting values (P-PRINT), enter the adjustment values and setting values for the following items in
service mode. Note that you cannot enter the counter value.
Service Mode
SORTER > ADJUST
ON
1 2 3
SW1
ON
1 2 3 4
SW1
STP-F1 Adjusting the front 1-staple position
STP-R1 Adjusting the rear 1-staple position
STP-2P Adjusting the front/rear 2-staple position
BFF-SFT Adjusting the displacement amount of the buffered paper (1st to 2nd
sheets)
BFF-SFT2 Adjusting the displacement amount of the buffered paper (2nd to 3rd
sheets)
SDL-STP Adjusting the stitching position of the saddle stitcher unit
SDL-FLD Adjusting the folding position of the saddle stitcher unit
SDL-ALG Adjusting the alignment width of the saddle stitcher unit
ST-ALG1 Adjusting the A4 size paper alignment position
ST-ALG2 Adjusting the LTR size paper alignment position
SW-UP-RL Adjusting the height of the swing unit
NST-SPD Adjusting the delivery speed at the non sort mode
FR-ST-PS Adjusting the binding pressure at the staple-free binding mode
FR-STP-Y Adjusting the binding position for the front/rear direction at the sta-
ple-free binding mode
RBLT-PRS Adjusting the height of the return belt
MSTP-2P Adjusting the front/rear staple position at the manual staple mode
181
4
SW2
SW2
Items
5. Adjustment