Canon Staple Finisher-AA1 Service Manual page 190

Service Mode
SORTER > ADJUST
SORTER > OPTION
*: The adjustment and setting values of this service mode for the puncher unit are stored by the finisher. The adjustment and
setting values of the following service mode are stored by the puncher unit.
• (Lv.1) SORTER > ADJUST > PNCH-Y
• (Lv.1) SORTER > OPTION > PUN-Y-SW
• (Lv.1) SORTER > OPTION > PNCH-SW2
If there is not the output of the "P-PRINT"
1. Set the SW1 keys as shown below and press the SW2.
CENT-ALG Adjusting the center standard position of the alignment plates
SDL-STP2 Adjusting the stitching position of the saddle stitcher unit (thin paper)
SDL-FLD2 Adjusting the folding position of the saddle stitcher unit (thin paper)
ESC1-SPD Adjusting the delivery speed of the escape tray
SFT-SPD Adjusting the delivery speed at the shift sort mode
STP-SPD Adjusting the delivery speed at the staple mode
RBLT-PS2 Adjusting the height of the return belt
RBLT-PS3 Adjusting the height of the return belt
BUFF-SW Setting ON/OFF of the buffer operation
1SHT-SRT Setting ON/OFF of the shift sort delivery operation for a sheet of
paper
FIN-SP1 Finisher special settings 1
FIN-SP2 Finisher special settings 2
MSTP-TMG Setting the staple timing at the manual staple mode
PNCH-SW3* Setting ON/OFF of the mode to improve the precision of the punch
hole position
SFT-CHNG Setting the delivery number of the stacking paper at the shift sort
mode
STP-ALG Setting the operation of the alignment plates at the staple and sta-
plefree binding mode
SDL-ALG Setting the paddle operation when stacking the paper in the saddle
stitcher unit
TRY-STP Setting whether to limit the stack capacity of the stapled or folded
sheets
TRY-LMT Setting whether to limit the stack capacity of the stack tray
ON
1 2 3
SW1
182
Items
4
SW2
5. Adjustment