Canon Staple Finisher-AA1 Service Manual page 59

The relationship between operation modes and shift positions is summarized in the following table:
Operation
Mode
Non sort 2-sided print of A3 and B4 sheets weighing less
than 64 g/m2
Shift sort Paper width: 210 mm to 297 mm
Paper length: 182 mm to 432 mm
Paper other than above
Staple A3, A4, A4R, B4, B5, 11 × 17, LGL, LTR, LTRR,
EXEC, 8K, 16K
Staple-free bind- A3, A4, 11×17, LTR, 8K, 16K
ing
• Front shift position
• Rear shift position
<Related service mode>
• (Lv.1) SORTER > ADJUST > ST-ALG1: Adjusting the A4 size paper alignment position
• (Lv.1) SORTER > ADJUST > ST-ALG2: Adjusting the LTR size paper alignment position
• (Lv.1) SORTER > ADJUST > CENT-ALG: Adjusting the center standard position of the alignment plates
• (Lv.1) SORTER > OPTION > STP-ALG: Setting the operation of the alignment plates at the staple and staple-free binding
mode
Paper
Rear Alignment Plate
Front Alignment Plate
Rear Alignment Plate
Front Alignment Plate
51
Shift position
Center reference Paper other than those on the left is
not stacked and passed through.
- Front shift position: 15
mm frontward from the
center reference position
- Rear shift position: 15 mm
frontward from the center
reference position
Center reference
Center reference
Center reference
Paper
Central Reference+15mm
Central Reference+15mm
Paper
2. Technical Explanation
Remarks