Removing The Saddle Stitcher Unit; Removing The Staple-Free Binding Unit - Canon Staple Finisher-AA1 Service Manual

1x
[2]
■ Handling after parts replacement
1. Clear the parts counter.
(LV1) COPIER > COUNTER > DRBL-2 > FIN-STPR
Removing the Saddle Stitcher
Unit
■ Preparation
1. Pull out the saddle unit (service position).
" Pulling Out the Saddle Unit (Service Position)" on page
131
2. Remove the lower front cover.
" Removing the Lower Front Cover" on page 94
■ Procedure
1. Remove the top plate [1].
• 2 screws [2]
• 2 insertion joints [3]
2x
[2]
2. Remove the saddle stitcher unit [1].
NOTE:
Check the Scale[5] before removing the Saddle Stitcher
Unit.
[1]
[1]
[3]
[3]
4. Parts Replacement and Cleaning
• 2 wire saddles [1]
• 1 connector [3]
• 4 screws [4]
1x
1x
4x
[4]
[1]
[4]
■ Handling after parts replacement
1. Clear the parts counter.
(LV1) COPIER > COUNTER > DRBL-2 > SDL-STP
2. Adjusting the saddle stitcher unit installation
position.
"Adjusting the Stitcher Unit Installation Position " on page
167
Removing the Staple-Free
Binding Unit
■ Preparation
1. Remove the rear cover.
" Removing the Rear Cover" on page 94
2. Remove the Stack Tray.
" Removing the Stack Tray" on page 96
3. Remove the Grate-Shaped Lower Guide.
" Removing the Grate-Shaped Lower Guide" on page
96
109
[5]
[2]
[3]