Table of Contents
Advertisement
4.4 General observations
Page 36
INGETEAM assumes no liability whatsoever for damages caused by
the improper use of the equipment. Any work on any of this equip-
ment and involving a change in the original electrical layout, must
fist be proposed to INGETEAM. This proposed new layout must then
be studied and authorised by INGETEAM.
The necessary safety measures must be in place to prevent unautho-
rised persons from handling the equipment and to keep them away
from the vicinity of the equipment. Warning signs to indicate the pre-
sence of personnel at work:
Lockout mechanisms or mechanical locking, by padlocks with keys,
for circuit breakers of an appropriate type.
These instructions must be easily accessible, close to the equipment
and within easy reach of all users.
Before installing and commissioning the equipment, please read the-
se safety instructions and warnings carefully and all the warning signs
placed on the equipment. Ensure that all warning signs are perfectly
legible and that any damaged or missing signs are replaced.
This section defines the preventive measures to be adopted when
performing all types of work on the equipment, in order to work safely and
control unavoidable hazards.
Protection against direct contact is provided by the enclosure with a
protection rating of NEMA 3R.
The equipment has been tested to the applicable standards and
regulations to ensure that it complies with the safety requirements, the
insulation distance values and the leakage lines for the voltages used.
The tools and / or equipment used for the equipment manipulation tasks
must have double reinforced insulation (class II).
Installation and Operation Manual
INGECON®SUN SMART U
AAS2000IKI05
AAS2000IKI05
Date: February 2011
Rev. _
Advertisement
Table of Contents
