Hazards Present And General Preventive Measures; Hazards And Additional Measures In Manipulation Work - Ingeteam Ingecon Sun Smart U Installation And Operation Manual

Installation and Operation Manual
INGECON®SUN SMART U
AAS2000IKI05

4.4.1 Hazards present and general preventive measures

4.4.2 Hazards and additional measures in manipulation work

AAS2000IKI05
Rev. _
Date: February 2011
• Impact against stationary objects:
- Inform the workers of the hazard.
- Adequate lighting.
- Work carefully.
- Maintain sufficient distance to avoid contact with the hazard (control
rod on circuit breaker door).
• Blows, jabs and cuts with objects and / or tools:
- Keep the cover closed when not working in the cubicle.
- Adequate lighting.
- Good housekeeping.
- Mandatory use of a helmet, safety footwear and gloves when required.
• Particle projection (fan):
- It is advisable to use anti-impact glasses when accessing the fan area.
• Electrical hazard:
- Comply with the provisions in the PPE section and in the General
Safety Conditions section.
- Inform the workers of the hazard.
- Comply with the provisions of applicable Federal, Statal and Local
laws and rules.
• Thermal contact:
- Inform the workers of the hazard.
- It is advisable to wear gloves.
- Disconnect the power supply and wait 10 minutes to allow the hot parts
in the equipment interior to cool down (R1, RAD1).
Thermal hazard
Page 37