Table of Contents
Advertisement
IMPORTANT SAFETY INSTRUCTIONS
SAVE THIS INSTRUCTIONS - DO NOT DISCARD
This manual contains important instructions for Models Ingecon Sun 15U 208, Ingecon Sun 15U
480, Ingecon Sun 25U 208 and Ingecon Sun 25U 480 that shall be followed during installation and
maintenance
of
the
appropriate).
WARNING
The operations detailed below should only be carried out by suitably qualified
personnel, trained to work with electrical equipment, familiar with this present manual
and the electrical drawings associated with the control panel (hereinafter referred
to as qualified personnel). You are reminded that it is compuslory to comply with
applicable legislation in terms of security for electrical work. There is an electrical
discharge hazard.
It is essential to read the manual before operating the equipment!
WARNING
The opening of the various compartment enclosures in no way implies that no voltage
is present inside. Access is therefore restricted to qualified personnel following the
safety conditions set out in this document.
WARNING
The set of conditions detailed below should be considered to be the minimum
requirements. It is always preferable to disconnect from the mains and check that
no voltage is present. Faults in the installation could produce undesirable voltage
returns. There is an electrical discharge hazard.
WARNING
In addition to the safety measures indicated in this manual, it is also necessary to
observe the general measures applicable to this field (specific to the installation,
country, etc)
WARNING
Compulsory to verify that no voltage is present: Use CAT III -
equipment.
Page 4
(blank
space
is
to
Installation and Operation Manual
indicate
inverter
or
INGECON®SUN SMART U
AAS2000IKI05
charge
controller
as
600 V
measuring
AAS2000IKI05
Rev. _
Date: February 2011
Advertisement
Table of Contents
