Table of Contents
Advertisement
3.5 Storage
3.6 Conservation
Page 32
If the equipment is not to be installed immediately after reception, then the
following points should be taken into account in order to avoid deteriora-
tion:
•
The package should be stored upright.
•
Keep the equipment free from dirt (dust, shavings, grease ...) and out
of the reach of rodents.
•
Avoid contact with water jets, welding sparks, etc.
•
Cover the equipment with a breathable, protective material in order to
avoid condensation caused by ambient humidity.
•
The equipment stored at the manufacturing plant and that stored on
the customer's premises must be maintained with the ambient condi-
tions indicated in section 3.2.5.
•
It is extremely important to protect the equipment from contact with
chemicals, which could cause corrosion, and also from saline atmos-
pheres.
In order to conserve the equipment correctly, the original packaging should
not be removed until just before the equipment is due to be installed.
In the event of prolonged storage, we would recommend storage in a dry
place, avoiding abrupt temperature changes, as far as possible.
Should the packaging be damaged /cuts, holes, etc) the equipment will not
be maintained in optimum condition before installation.
INGETEAM ENERGY S.A. assumes no liability if this condition is not com-
plied with.
Installation and Operation Manual
INGECON®SUN SMART U
AAS2000IKI05
AAS2000IKI05
Date: February 2011
Rev. _
Advertisement
Table of Contents
