Personal Protection Equipment (Ppe) - Ingeteam Ingecon Sun Smart U Installation And Operation Manual

Installation and Operation Manual
INGECON®SUN SMART U
AAS2000IKI05

4.5.4 Personal Protection Equipment (PPE)

AAS2000IKI05
Rev. _
Date: February 2011
1. Disconnect
Open all possible voltage sources. Take into account the fact
that capacitors or other devices powered from uninterrupted power
sources (UPS - SAI) will still hold voltage after disconnection.
2. Prevent any possible reconnection of the power
The switching devices used to disconnect the installation should
be blocked to guard against any possible reconnection.
3. Check that no voltage is present
Check all the live parts of the electrical installation or as close as
possible to the work area in order to ensure that no voltage is present.
4. Ground and short circuit the equipment
In low voltage installations, where there is a risk that the parts might
accidentally become live due to induction or for any other reason.
And always in high voltage installations..
5. Demarcate and place warning signs in the work area.
Inspection:
It is mandatory to wear helmet compliant with security standards. It is also
mandatory to wear safety gloves, of the mechanical type, for voltage free
work.
Operational task:
It is mandatory to wear a helmet compliant with with security standards. It
is also mandatory to wear safety gloves, of the mechanical type, for voltage
free work.
It is also mandatory to wear dielectric gloves that are compliant with with
security standards. and a safety face mask that provides protection against
short electric arcs and is compliant with with security standards, in tasks
involving adjusting the heating / ventilation systems, when connecting and
disconnecting the voltage and when performing checks at safe measurement
points.
Manipulation:
It is mandatory to wear a helmet compliant with with security standards..
It is also mandatory to wear dielectric gloves that are compliant with with
security standards. and a safety face mask that provides protection against
short electric arcs and is compliant with with security standards., when
connecting and disconnecting the voltage and when accessing cubicles
with live parts.
Page 39