Equipment Transport - Ingeteam Ingecon Sun Smart U Installation And Operation Manual

Installation and Operation Manual
INGECON®SUN SMART U
AAS2000IKI05

3.4 Equipment transport

AAS2000IKI05
Rev. _
Date: February 2011
Correct transport and storage are the first steps required for correct
equipment use and operation. Considering the indications given in section
3.3 and as a preventive measure INGETEAM would recommend working with
hauliers specialising in the transport of special and / or fragile equipment.
During transport and storage the equipment should be protected from
mechanical impacts, vibrations, water projections (rain) and any other
product or situation which could damage or alter its performance.
Failure to comply with these instructions could void the product warranty,
for which INGETEAM is not liable.
When moving this equipment, bear in mind that the equipment centre of
gravity is at 1/3 the height of its plan view projection.
Transport by truck
To transport the INGECON-SUN SMART U on a truck, it is essential
to maintain the equipment upright and correctly anchored, considering its
weight and dimensions, in order to avoid it tipping over or being damaged
by impact.
Moving the equipment with a fork lift truck
At least the following points should be observed:
1) Ensure that the packaged equipment is centred over the forks.
2) Try to ensure that the equipment is placed as close as possible to the
connection between the fork and the carriage.
3) Ensure that the forks are perfectly level, to prevent the equipment from
being tipped off..
4) In any event, observe the instructions provided in the fork lift truck ma-
nual.
Page 31