Installing The Unit; General Requirements For Installation; Attaching The Unit To The Wall - Ingeteam INGECON SUN 1Play TL M Installation And Usage Manual

Ingeteam

7. Installing the unit

Before installing the unit, the packaging must be removed, taking special care not to damage the housing.
Check that there is no condensation inside the packaging. If there are signs of condensation, you must not install
the unit until you are sure it is completely dry.
All installation operations must comply with current regulations.
All operations involving moving heavy weights must be carried out by two people.

7.1. General requirements for installation

• The environment of the unit must be appropriate and meet the guidelines described in Chapter "6.
Preparation for installing the unit". Additionally, the parts used in the rest of the installation must be
compatible with the unit and comply with the applicable legislation.
• Ventilation and the space for work, which must be suitable for maintenance tasks according to the
applicable regulations in force.
• The external connection devices, which must be suitable and sufficiently close as set forth in current
regulations.
• The feed cables must be of the appropriate gauge for the maximum current.
• Special care must be taken to ensure that there are no external elements near the air inlets and outlets
that obstruct proper cooling of the unit.

7.2. Attaching the unit to the wall

These units have a system for securing them to the wall using a plate. The steps for fixing the unit properly are as
follows. The weight of the unit must be taken into account.
The top attachment plate for the unit supports the weight. The bottom point fixes the inverter to the wall and
prevents vibrations.
1. Unscrew the retaining screw and remove the plate and remove the unit, as shown in the following figure.
2. Mark the attachment points for the plate and the lower anchor hole on the wall. Use the template
provided with the unit.
3. Drill holes in the wall with a suitable bit for the screws to be used to secure the plate to the wall later.
60 ABE2011IQM01_ - Installation and usage manual
Installing the unit