Static Routes; Table 10: Ucm6100 Network Settings→802.1X; Table 11: Ucm6100 Network Settings→Static Routes - Grandstream Networks UCM6100 Series User Manual

802.1X Mode
Identity
MD5 Password
802.1X Certificate
802.1X Client
Certificate

Static Routes

The UCM6100 provides users static routing capability that allows the device to use manually configured routes,
rather than information only from dynamic routing or gateway configured in the UCM6100 web GUI→Network
Settings→Basic Settings to forward traffic. It can be used to define a route when no other routes are available
or necessary, or used in complementary with existing routing on the UCM6100 as a failover backup, and etc.
•
Click on
create a new IPv6 static route. The configuration parameters are listed in the table below.
•
Once added, users can select
•
Select to delete the static route.
Destination
Netmask
Table 10: UCM6100 Network Settings→802.1X
Select 802.1X mode. The default setting is "Disable".
The supported 802.1X mode are:
•
EAP-MD5
•
EAP-TLS
•
EAP-PEAPv0/MSCHAPv2
Enter 802.1X mode Identity information.
Enter 802.1X mode MD5 password information.
Select 802.1X certificate from local PC and then upload.
Select 802.1X client certificate from local PC and then upload.
to create a new IPv4 static route or click on
to edit the static route.
Table 11: UCM6100 Network Settings→Static Routes
Configure the destination IPv4 address or the destination IPv6 subnet for the
UCM6100 to reach using the static route.
Example:
IPv4 address - 192.168.66.4
IPv6 subnet - 2001:740:D::1/64
Configure the subnet mask for the above destination IPv4 address. If left blank,
the default value is 255.255.255.255.
Example:
255.255.255.0
UCM6100 Series User Manual
Version 1.0.18.13
to
P a g e | 69