Static Routes; Table 9: Ucm6100 Network Settings802.1X; Table 10: Ucm6100 Network SettingsStatic Routes - Grandstream Networks UCM6100 Series User Manual

Select 802.1X mode. The default setting is "Disable".
The supported 802.1X mode are:
•
802.1X Mode
•
•
Identity Enter 802.1X mode Identity information.
MD5 Password Enter 802.1X mode MD5 password information.
802.1X Certificate Select 802.1X certificate from local PC and then upload.
802.1X Client
Select 802.1X client certificate from local PC and then upload.
Certificate

Static Routes

The UCM6100 provides users static routing capability that allows the device to use manually configured
routes, rather than information only from dynamic routing or gateway configured in the UCM6100 web
GUINetwork SettingsBasic Settings to forward traffic. It can be used to define a route when no other
routes are available or necessary, or used in complementary with existing routing on the UCM6100 as a
failover backup, and etc.
•
Click on
listed in the table below.
•
Once added, users can select
•
Select to delete the static route.
Destination
Netmask
Table 9: UCM6100 Network Settings802.1X
EAP-MD5
EAP-TLS
EAP-PEAPv0/MSCHAPv2
to create a new static route. The configuration parameters are
to edit the static route.
Table 10: UCM6100 Network SettingsStatic Routes
Configure the destination IP address or the destination IP subnet for the
UCM6100 to reach using the static route.
Example:
IP address - 192.168.66.4
IP subnet - 192.168.66.0
Configure the subnet mask for the above destination address. If left blank, the
default value is 255.255.255.255.
Example:
255.255.255.0
UCM6100 Series User Manual
P a g e 60
|